|
| How To |
|
How to Contact us:
By Email: casdanben@aol.com
By phone 330-412-6264
By US Mail
Michelle's Scrapbooking & More
6455 Ridgeview Dr SE
Waynesburg, OH 44688
------------------------------------------------------------------------------------------------------
How do I use a Spellbinders Die to cut in the CuttleBug ™ by Provocraft®?
You will need Spellbinders Tan Embossing Mat to emboss in Cuttlebug™ machine. Create a sandwich in the following order from the bottom up:
1. A plate
2. C plate
3. Spellbinders Die (cutting side or ridged side up)
4. Paper or cardstock
5. B plate
6. Run through Cuttlebug™ machine
- How do I use a Spellbinders Die to emboss in the CuttleBug ™ by Provocraft®?
- Create an “Embossing Sandwich” using the following stacking from the bottom up. * If embossing right after cutting remove the C Plate for embossing sandwich.
1. Place A plate on bottom
2. Leave die face up on A plate with die cut still in the die.
3. Place one Spellbinders Tan Embossing Mat on top of the die.
4. Use 2 or 3 pieces of cardstock to shim. *Cautionary Note: Using more than 3 pieces of cardstock to shim Cuttlebug Embossing sandwich will result in B Plate breakage. When using Spellbinders Edgeabilities card making dies, shim with only 2 pieces of card stock.
5. Place two acrylic B plates on top of sandwich and run thru Cuttlebug machine to emboss Spellbinders die cuts.
6. Turn die over and use like a stencil with inks and chalks for added detail.
- How do I cut with a Spellbinders Die in the Original Sizzix® Press?
- You will need to use the Sizzix® System Converter by Ellison® and Spellbinders Spacer Plate to cut with Spellbinders Dies. Create the below sandwich stacking from the bottom up:
1. Place the Sizzix® System Converter into the Sizzix® Machine.
2. On the Cutting Pad, place paper to be cut, then Spellbinders Die, ridges down.
3. Place the Spellbinders Spacer Plate (Item# W 004) over the Spellbinders Die.
4. Use a 12x6 piece of cardstock and tri fold to use as a shim. Place shim on top of Spellbinders Spacer Plate.
5. Push through Sizzix® Machine to cut. NOTE: It may take several presses to cut larger Spellbinders Dies.
- How do I emboss with a Spellbinders Die in the Original Sizzix® Press?
- You will need to use the Sizzix® System Converter by Ellison® and Spellbinders Tan Embossing Mat to emboss with Spellbinders Dies. After cutting with a Spellbinders Die in Sizzix® Machine, remove paper shim and spacer plate. Create the below sandwich stacking from the bottom up:
1. Leave paper die cut in the die.
2. Turn over Spellbinders Die, placing it on Sizzix® cut pad.
3. Place Spellbinders Tan Embossing Mat on top of Spellbinders Die.
4. Place paper shim on top of Tan Embossing Mat.
5. Push through Sizzix® Machine to emboss the Spellbinders Die.
-
|
|
|
|
|
